brisbrutale
Member
- Joined
- Mar 20, 2010
- Messages
- 31
- Reaction score
- 0
Yeah nice tray!
You're not brisbrutale from the bike forums are you?
Welcome aboard!
When you say "thirsty", just how bad are we talking about?
TO RESET
To carry out the reset carry out the following
Turn ignition on so all dash lights come on.
Wait 3 seconds
PUMP accelerator pedal 5 times within 5 seconds....
with foot now OFF accelerator wait 7 seconds...
After 7 seconds press and hold down accelerator pedal for 10 seconds...
After 10 seconds the Engine Management Light will start to flash, at this point remove foot from accelerator.
the Nav is now in diag mode, so let the EML flash for a bit. the press and hold the accelerator pedal down for more than 10 seconds..this will then reset ECU and fuel pump etc......and put them into learning mode.
NOTE: When the EML light is flashing, this is listing possible fault codes... so if you know how to read the fault codes or know the sequences then you can figure out any possible faults with your Nav with out getting the dealer to do it!!
Enter your email address to join: