kerrie0400
Member
- Joined
- Dec 9, 2010
- Messages
- 28
- Reaction score
- 0
so we replaced the cylinder head on our zd30 put it all back together and it wouldnt start.
We took the injectors out and and turn the motor over and we could see diesel spraying out all injecctors so we pulled it all down again to check the timing and as far as we can tell its all good.
the way we set the timing when pulling it off was by lining up the yellow chain piece with the bottom mark on the fuel injection pump sprocket and on the cam sprocket lined up the 2 blue chain pieces up the top with the 2 marks and had it all lined up on an angle.
After doing that we pulled it all off but we did mark on the cam sprockets what position they were in before pulling them off with nail polish.
did we miss doing something?
how do we reset the timing if we got it all wrong?
We took the injectors out and and turn the motor over and we could see diesel spraying out all injecctors so we pulled it all down again to check the timing and as far as we can tell its all good.
the way we set the timing when pulling it off was by lining up the yellow chain piece with the bottom mark on the fuel injection pump sprocket and on the cam sprocket lined up the 2 blue chain pieces up the top with the 2 marks and had it all lined up on an angle.
After doing that we pulled it all off but we did mark on the cam sprockets what position they were in before pulling them off with nail polish.
did we miss doing something?
how do we reset the timing if we got it all wrong?