Clutch Problems

[Farmer Joe]

My D22 all of a sudden become hard to get in gear when stationary.
I had to turn motor off and start it in gear to get mobile, I checked master and slave cylinders and neither are leaking. I checked slave travel and there seemed to be plenty, then all of a sudden it came good and gear changing was all good. About two hours later it all started again and now I can't get gears again.
I suspect thrust bearing or presure plate probs. What do you guys recon?
fj

 

[tweak'e]

spigot bearing seizing.

 

[Farmer Joe]

spigot bearing seizing.

OK tweak'e so a seized spigot would prevent the input shaft from stopping
when you depress clutch. Is that what you mean?

 

[big zetor]

have you parked it near a d40! it might of caught somthing

 

[Farmer Joe]

Still having problems with my clutch.
Most of the time it is ok, then all of a sudden you can't get it in
gear without turning the motor off and re-starting in gear,
then the vehicle creeps forward even though clutch is fully depressed.
Then next time you pull up it may be ok.
I suspect the master cylinder although there is no fluid loss!!
There is no fluid loss at slave either.
Any sugestions??
fj

 

[Farmer Joe]

Still having problems with my clutch.
Most of the time it is ok, then all of a sudden you can't get it in
gear without turning the motor off and re-starting in gear,
then the vehicle creeps forward even though clutch is fully depressed.
Then next time you pull up it may be ok.
I suspect the master cylinder although there is no fluid loss!!
There is no fluid loss at slave either.
Any sugestions??
fj

I have renewed the master cylinder, but the problem is still there.

Does anybody have any ideas??

fj