Hey everyone, still new to this forum and finding it fantastic.
I started a thread a week or so ago and have an update on it.
I have recently purchased a 2008 4.0l STX. I have 0420 and 0430 codes plus an intermittent ABS light. I recieved some super helpful advice on here and today finally got time to put it up on the lift.
I found 2 plugs going to the front of the transfer case both with 2 wires each. One with yellow and black the other red and black. All but 1 of the wires were broken after a cable tie holding them up had deteriorated and dropped the loom down on the front drive shaft. Both of these plugs have wires that appear to travel to the two rear 02 sensors. One of the plugs i need to replace has the wire snapped off inside the plug. Im hoping someone on here may know the name of the plug? To me it appears it is plugged to some sort of sensor in the transfer case that also includes the 02 sensor. The Nav still switches between 4low, 4high and two wheel drive fine.
Cheers Sam
I started a thread a week or so ago and have an update on it.
I have recently purchased a 2008 4.0l STX. I have 0420 and 0430 codes plus an intermittent ABS light. I recieved some super helpful advice on here and today finally got time to put it up on the lift.
I found 2 plugs going to the front of the transfer case both with 2 wires each. One with yellow and black the other red and black. All but 1 of the wires were broken after a cable tie holding them up had deteriorated and dropped the loom down on the front drive shaft. Both of these plugs have wires that appear to travel to the two rear 02 sensors. One of the plugs i need to replace has the wire snapped off inside the plug. Im hoping someone on here may know the name of the plug? To me it appears it is plugged to some sort of sensor in the transfer case that also includes the 02 sensor. The Nav still switches between 4low, 4high and two wheel drive fine.
Cheers Sam