just got in from installing boss load assist air bag kit on the single cab D23 np300 navara (leaf spring rear).
sorry no pics just yet. need cold one first.
so far the kit leaves a bit to be desired.
the bottom mount needs a corner cut off to clear a brake line mount on the axle.
the top mount doesn't fit all that well. the chassis it clamps around is tapered but the air bag mount is straight, so its doesn't fit all that nicely. especially as there is wiring and brake lines that it actually hits. had the pull the wiring clip off and bend the brake line a bit for clearance.
it would have been so much better if they had made the mount offset a bit and wider to clear everything.
no split convoluted tubing in the kits to put the air pipe in for a bit of protection.
the amount of air tubing was a bit tight. that limited where i could put the air valves.
also everything is imperial sized.
how does it ride? i'll find out on monday.
sorry no pics just yet. need cold one first.
so far the kit leaves a bit to be desired.
the bottom mount needs a corner cut off to clear a brake line mount on the axle.
the top mount doesn't fit all that well. the chassis it clamps around is tapered but the air bag mount is straight, so its doesn't fit all that nicely. especially as there is wiring and brake lines that it actually hits. had the pull the wiring clip off and bend the brake line a bit for clearance.
it would have been so much better if they had made the mount offset a bit and wider to clear everything.
no split convoluted tubing in the kits to put the air pipe in for a bit of protection.
the amount of air tubing was a bit tight. that limited where i could put the air valves.
also everything is imperial sized.
how does it ride? i'll find out on monday.