Bill Parks
Member
3 years ago and approx 50,000 K's I had a Tough Dog suspension lift put in Nav.
I just noticed the other day that the driver side seems to be a bit lower than the passenger side.
So I measured from the concrete floor in my garage to the bottom of my flares and these are the measurements I got.
Passenger rear 991mm
Passenger front 885.5mm
Drivers rear 888.5mm
Drivers front 885.5mm
I ran the tape up through the center of the hub against my 4' level to I knew the tape measure was level.
There is only about 20L of fuel in the truck so I would not think that would be an issue.
The only thing in the back of the truck is my Outback drawers (empty) and Flexiglass canopy (with roof racks only).
My question is . Should I be worried about the difference in heights between the drivers rear and passengers rear?
Thank you in advance for the assistance...
Bill
I just noticed the other day that the driver side seems to be a bit lower than the passenger side.
So I measured from the concrete floor in my garage to the bottom of my flares and these are the measurements I got.
Passenger rear 991mm
Passenger front 885.5mm
Drivers rear 888.5mm
Drivers front 885.5mm
I ran the tape up through the center of the hub against my 4' level to I knew the tape measure was level.
There is only about 20L of fuel in the truck so I would not think that would be an issue.
The only thing in the back of the truck is my Outback drawers (empty) and Flexiglass canopy (with roof racks only).
My question is . Should I be worried about the difference in heights between the drivers rear and passengers rear?
Thank you in advance for the assistance...
Bill