Recent content by jfc21456

Hi, No I never did find a successful modification, so I kinda lost interest.

Hi many thanks for taking the time to reply. I am like you, I cannot find anyone who has lowered this ute. The main reason is that my wife has difficulty with entering the ute,I am getting side steps first, but I am going to find someone who may be able to lower the ute, and when/if I get it...

Hi, I have a 2010 navara d40 4wd auto,dual cab, Thai bld., with 265/70/r16 tyres, and I think the suspension is stock standard. I cannot find any lift blocks etc.. Iwish to try to lower the ute by at least 50mm. Has anyone tried to do this ?, any thoughts on how to go about it, ?. I would...

Hi, I brought the Alernator from S.A,,via ebay search, Supplier is " naparts 50064 " Postage free. Been on my ute over a month now and no problems. HOWEVER, the first one he sent over , had a tight spot when turning by hand, so I asked for a replacement. No problem, 2nd unit was sent priorty.By...

Hi, I will add my 2 bobs worth here. My rig is 2010 Thai d40 auto with 130k, and recently it siezed the altrnator up tight as a drum ,doing 2500 rpm at the time and stalled the engine. Took the Alt. apart and found the small double row bearing at the brush end had dismantled itself,and made...

Hi,just read this report. YD25.com , in Murraie Qld,used to sell the rocker cover seals in a kit. I have used them.and it is a bit of mucking around to pry the old ones out and put the new ones in. It is a lot cheaper than a new R/C

Hi, I have recently changed the auto trans oil in my 2010 D40 navara, and after geting various prices ,I found the 4 litres genunine packs from Nissan (sunshine coast ) was around $45.00 from memory, which was comparable to supa cheap/autobarn etc. Tom

Hi Mongolia from sunny Queensland. I have a 2010 navara d40 (Thai Bld ) diesel/auto. I removed this pipe from mine at about 90000 klms to delete the EGR . It is in very good condition. If you want it, its yours for free. No idea how to get it to you. Let me know.regards TOM

Hi, I may as well throw in my 2 bobs worth. Presume it is something simple. Disconnect the exhaust pipe at the manifold and see if the engine will rev freely, all the best TOM

Hi, I know nothing about the D22, however if it has the YD25, then I will say its the worst job I have done on that engine ( mine is D40, 2010 Navara ). In the end I removed the oil filter housing, transmission and engine oil filler tubes, and finished up screwing a 1/8 npt straight fitting into...

Could you get access to the transmission module ( auto box ) ? Tom

I run a2010 , Thai bld.D40 5 speed auto, 93000 klms. I recently installed a temp sensor in the trans. oil cooler line at the g'box. The temp ran up to 100C on the way up to Malanda, cool evening, not towing and only lightly loaded . The oem cooler seems big enough (590mm x 200mm x 20mm ),and...

Hi Scott. Many thanks for your reply. I have seen the video you refer to, and there is no way my rocker cover insides look like that one. I have since found out that yd25 keep the seals, so my next shot will be to find out what method they use to remove the old ones. As you say the old seals are...

Hi all, I have been following the ebb and flow of many conversations on this forum, and now need some help myself. Has anyone developed a method of removing and replacing the injector seals in the plastic rocker cover of the YD25. My veh. is 2010 Navara D40 , diesel auto (Thai. bld.) Any ideas...