Lifted std bullbar after 2" body lift

[Stellafella]

 

[fudly]

how you do it just redrilled holes??

 

[Stellafella]

Took bumper off

Measured 60mm up on bracket mounted to the car for the bottom hole

Then measured 60mm down on the top hole on the bull bar and drilled 12mm hole for bolts easy as

 

[loco12]

Just wondering why you moved the bar 60mm instead of 50mm like the body lift? The gap between the bar and flares looks too small now and they may come in contact with each other now.

 

[Stellafella]

Center punch once marked then Small pilot hole then 8mm hole then 12mm drill bit. I would advise going 13-14mm just so u have room to jiggle it i didnt and it was very tight fit. Luckily i measured twice coz i wasnt taking it off again on my own

 

[Stellafella]

I didnt like the 15mm gap it already had and that pic was taken b4 all bolts were tight

 

[ben85]

there's meant to be a gap, the body and bullbar move independently and will rub, probably quite a lot offroad.

 

[Stellafella]

Read above^^^^

 

[Stellafella]

I tinkered with stock bash plate tonight to make it fit after lifting bullbar.