gunning1987
Member
Here's a quick run through on how to cut and mount the ARB bullbars to the D40's. This is THAI maybe different to SPAIN so read the instructions what come in the packaging.
Shopping basket:
1x 15mm masking tape
1x 30mm masking tape
1x A4 sheets of fine sand paper (round 120 will do)
2x mate to help lift the bullbar on.
Jigsaw with plastic cutting blade
Drill with 3/8" (10mm) drill bit
Basic hand tools kit
Torque Specs:
3/8= 35 FT/LB +/-5
1/2= 60 FT/LB +/-10
9/16= 100FT/LB +/-20
1: Remove number plate, bottom bumper skirting and screws from wheel well guards to front bumper. Run the 15mm tape along the lower edge of the bottom recess on the bumper bar, then the 30mm tape 3mm about. I used a 3mm wide screw driver as my guide.
2: Using the jig saw cut in between the 2 tape guides, allowing the jigsaw to cut the plastic rather then melting. This doesn't have to exact as the bullbar covers the cut once fitted, but stay between the lines
Shopping basket:
1x 15mm masking tape
1x 30mm masking tape
1x A4 sheets of fine sand paper (round 120 will do)
2x mate to help lift the bullbar on.
Jigsaw with plastic cutting blade
Drill with 3/8" (10mm) drill bit
Basic hand tools kit
Torque Specs:
3/8= 35 FT/LB +/-5
1/2= 60 FT/LB +/-10
9/16= 100FT/LB +/-20
1: Remove number plate, bottom bumper skirting and screws from wheel well guards to front bumper. Run the 15mm tape along the lower edge of the bottom recess on the bumper bar, then the 30mm tape 3mm about. I used a 3mm wide screw driver as my guide.
2: Using the jig saw cut in between the 2 tape guides, allowing the jigsaw to cut the plastic rather then melting. This doesn't have to exact as the bullbar covers the cut once fitted, but stay between the lines