Search results

Could a dud battery (cell shorted, only providing 10.7v) have been causing the titular error code when the battery was beginning to fail? The daughter's d40 has had an intermittent issue with this failt sending the vehicle into limp. The only time I could get it started on the weekend, before...

The daughter's nav has a fuel pre-filter/water separator mounted down on a chassis rail. A quick google says it is used on massey ferguson tractors. Having purchased a standard filter in advance of a planned filter change, I am now wondering whether we should just bypass the pre-filter until...

Been struggling with a P0093 error and limp mode on cold start for quite some time. Replaced pressure relief valve some months ago which seemed to settle it for a while, but now the weather is colder it has raised its head once more. Threw some injector cleaner in it a week or two ago and it...

Hey guys, Needing to do the brake master cylinder but repco lists 2 part#'s without definitive differences between the two which might be used to determine if one is better than the other or not ... has anyone come across this who can guide me? Cheers.

Where do I start? Brake fluid is fine, no change in braking apparent.

Replacing the exhaust manifold gasket on the daught's d40 ... only success I have ever had with exhaust manufold gaskets on my AU Falcon have included retorqueing after a few trips when the gasket settles in. This doesn't look possible without completely removing the turbo and heat shield a...

Can anyone give me an idea of the amount of work involved? Replaced the turbo ourselves earlier in the year, and now seeing the tell-tale soot spatter coming from the manifold to head gasket interface. Even checking that the nuts are tight seemsa bit of a pain with all the heat shielding and...

1st start ran very rough and stalled. Immediate limp mode on 2nd start with check engine light. Logged a P0093 error code which is supposedly a fuel leak/ fuel system issue. Had a good look over it and there are definitely no fuel leaks. Cleared the fault code and restart seems fine. What sort...

Just wondering what might have been unbolted from this position? Noticed a rattle when the bonnet was off doing the turbo and found the nut with its assembly enabler rod rattling free inside and this looks like the only hole that used to have something bolted in place ....

I will start at the beginning, so information can be relayed in full and in correct order. Daughter bought a 2007 D40 that had done a lot of work, but had just had the timing chains done, and had a box full of most of the running gear parts that were going to be needed for a roadworthy. It had...

Daughter reports revs of close to 4000 before any change of gears in general driving. This has been since a loss of boost issue was seemingly rectified by changing the vacuum lines and boost solenoid for new. When I have been in the car it seemed it could have been an intermittent problem, or...

Daughter's D40 again .... Before shift running fine ... getting off shift after midnight and zero boost pressure reading on aftermarket gauge and car won't go over 25k. She tells me the airbag light has been flashing for a couple of weeks, but no engine check light on ... All hoses to the...

Looking for something cheap to give the daughter for her new ride and thought covers for the front hub nut on her 2007 d40 would make the black sunraysias look neater ... can anyone point me to something that would fit? Cheers.

Hi guys - trying to work through the roadworthy list for the daughter's new ride; the only how to I can find on U-toob has the guy hook the red retainer ring out with an allen key before removing the seal. The one in the daughter's seems to be stuck fast; even a jerry rigged slide hammer...