Recent content by HEM49

I’m chasing a rear diff (even just ring and pinion) for my yd25, I’m one of the lucky ones that vin plate doesn’t match ratio. It’s stamped CA39 but it has 4.625 in it, iv owned car from new, this is that ratio it came with. I’m finding it hard to get wrecking yards to actually count the teeth...

Iv just arrived in Sydney from cairns and my manifold has cracked. Does anyone have an original laying around I could buy. Being so close to Christmas I’m finding it hard to get one before Christmas.

Iv just done the rear crown and pinion on my 2010 d22 2.5, the compliance plate says CA39 but stamped on the crown is 37:8 (4.625). Iv owned the car since new and had an air locker fitted right away, thats the only time the diff has been opened. Has the factory fd up somewhere or did arb?

Just did the rear diff on the weekend, 3 teeth of the crown wheel. Where is a good place to get a new crown wheel, pinion and seal from that deliver.

Does the DP31T2B chip fit 2010 2.5 d22

46mm sag in the rear and they didnt put on the right springs in the first place, ARB have said that yes ill get new springs

it might not be the best but 3 year 60000km warranty means im covered untill middnight the day before and right up to 59999km. 1'' front and 2'' rear from there installed measurements is bull.I cant get any arb to book my car into measure the height is my biggest pain

always had staun, a set at 16psi and a set at 20psi. Screw on and go, iv always been iffie about unscrewing the valve. Realy does it mater, as long as the wife sets the right pressure

Has anyone had any problems with making a claim. I had my 2010 d22 looked over by pedders and they found a few problems, i called arb as its still under warranty (2years and 59000km) and there telling me that its suspension settle not sag. Iv lost 20mm fr, 24mm fl, 45mm rr and 46mm lr. Iv got...

Its an arb one and im going to drill a hole near the light, im not going to drill the glass im going to drill the canopy

Has any one fitted a wiper motor to there canopy, im sick of not being able to see out the back. I was think maybe one out of a van, with a toggle switch in the cab for both on/off and water sprayer. Im off to the wreckers this weekend, just after ideas.

Abyone run a 12' tinnie ontop there d22. iv just got one and am after (cheap) ideas for transporting it on the roof. Its just for onroad use and theres no trailer. Id love one of the boat loaders that are out there but $1600 is way to much. Iv got a canopie with arb racks. Any ideas would help

There 265 75. I Run 18 offroad and 36 onroad. Coopers head office are calling it stock fold, get a new one tomorrow and mate is getting his friday (17").

Iv got a set on my d22 and had them for 8000km. When airing up (after doing the CREB) yesterday a mate in is prado with 4000km old st maxx noticed what looked like tyre damage but he has them on all 4 in the same spot. 1cm above the rim around the bead area, i checked out mine and iv got the...

Iv just got my hands on one of these 34M Optima Blue Technical Specifications: Volts12 Cold Crank Amps (CCA) @ -18oC 800 Reserve Mins (RC) @ 25oC100 AH 50 My question is if i want to run 2 40lt engel fridges while camping will a 80w solar panel be big enough to keep the battery topped up. The...