Recent content by Kaelandenys

Priming before starting has seemed to have made a difference. Is there anywhere in particular that commonly leaks?

Thanks for the reply, I’ll try see if I can locate a leak and get back to you

Gday guys, on cold start engine runs low on power and is quite gutless for about 10 - 15 seconds then will come good and drive great. Fault only occurs on cold start. Thinking maybe injector issue? Have replaced vacuum lines and fuel filter, no logged DTC’s and no lights on dash. Any help...

I’ve got one in the way to check just that. Just wanted to see if anyone else has run into a similar issue

G’day Just put in an electronically controlled boost gauge into my yd25 d40, it works great but according to this gauge, I’m pumping out 30 psi. It hasn’t had a tune or any ecu work to my knowledge. I have it plumbed Into the drivers side pressure sensor on the intercooler. Any help would be...

Hey guys, was looking at putting a steel snorkel on my 2008 st-x and was just curious as to what you guys have on your own rigs. Just a “who’s got what and where from” type thing. cheers

Hey guys, was looking at putting a steel snorkel on my 2008 st-x and was just curious as to what you guys have on your own rigs. Just a “who’s got what and where from” type thing. cheers

Hey all, just recently installed a SAAS boost gauge to my d40 and its reading super high, like further than the numbers reach high. It does the whole buzzing thing which I know you can fix with a restrictor, but I was just curious as to whether the high reading was a part of that or something...

So are all RX’s Thai built?

Hey guys, I own a 2009 D40 ST-X and am looking to put a bull bar on it. I’ve found one I like the look of but according to the website, it’s suitable for a D40 RX. From what I can tell they don’t appear to be any different from the ST-X externally. So my question is are there any external...