Recent content by hedgie

Out of curiosity how much has everybody been quoted to get the timing chains replaced? Around 5K sound right?

Howdy All, The car, 08 D22 CR YD25 Jap Built 125XXXkms. Appears my Injection pump is slowly dying, it can be heard kilometres away now. It used to do it only when coasting but now will knock very loudly under load also. Fuel filters done every 10k. Injectors 3 in 1 cleaned. Always ran good...

For Sale: Item:DP CHIP suit D22 YD25 2.5 Turbo Diesel Condition: Used but working 100%. Currently fitted to vehicle. Price: $500 Item:D40 Drive belt pulley RPU659 Brande new Repco Pulley "flat pulley OD84 ID12 W29" Condition: Brand New Price: Make me an offer Location: Canberra Cheers...

Hey all, Can any one please point me in the direction for the DPCHIP installation instructions? Assuming it just plugs into fuel rail path, anything else I need to be aware of? Cheers in advance. I have searched but no luck. Hedgie.

Must be different on the YD25. mine only has a MAF (or what looks awfully like one) behind the air box, IE down stream on the intake before the turbo inlet

Any idea if this works with a D22 yd25? Cheers, Tom

Am I right in assuming the air temp sensor is also referred to as MAF? Well at least it looks like a MAF to me, behind the air box.

Mine sits a lick under 2500 at 100kph. Spot on with me mates 2012. FFS!

Yeah mines Apr 08 so that would be the case then. Now that you say it, that really does feel where the powers going. Engine runs like a dream. Cheers, Hedgie

I Appreciate everyone's replies by the way! has been helpful. Cheers! Hedgie

Definitely jap built has it on the plate. my research is that they were 08-09 D22 YD25 then 2010 started building the D22 in Thailand Just cleaned the MAF so will see if that makes a difference. It doesn't blow any soot even before the EGR mod another thing I noticed. Ill see if I can get my...

I did mine on my 08. you have to loosen all 4 on the same side and jack up the body to replace the topsides on the body mount under the cab. ( leave the other side done up so it doesn't slide off!) I did only a couple and the issue persisted until I replaced all 8 on the cab. So in hindsight...

Hey Guys, Car: I have a Jap built 2008 2.5CR owned it since 50XXX now 100XXX, Bullbar, snorkel, K&N, EGR mod, 265/75 and rear bar. serviced it myself every 5k penrite and filter and serviced to logbook every interval. Question: Is it normal for me to get smoked by my mates thai built D22? I...

Yeah I've been looking into building a steel tray for a while, at the moment the tub is too handy for carting sand/soil etc.

Hey Guys, Will the longer tub from the later thai models fit the older jap models? Looking under my mates it appears they tacked on some extra chassis rail for the rear mount of the longer tub. So my initial thought was I would need to do similar. My tubs cracked apart from having the...