Search results

When the chassis bend they usually go the other way.

I have Safety Dave TPMS on my D23 and caravan. They have worked well. They detected a couple of slow leaks but were a bit slow on warning when I had a blowout.

Is it a self locking dif or does it require to be locked manually? If it is the latter then you will need to add the extra bits if you require the locking function.

Do those trailers work OK on other vehicles?

As a guess, I would say that that is the only trailer with incandescent globes fitted to it. The rest of the trailers have LED lights. Are you propositions correct? The D40s have monitoring to check if there are trailer lights connected. It is that monitoring that is causing the trailer lights...

A phone call (08 8670 7835) to the Mt Dare hotel will give you a sure answer

A few years ago I was quoted just over $6k by an agents service establishment and an NRMA workshop. It is not a simple case of replacing the chain up front. They also need to get to chains in the sump. The pully on the oil pump is not replaceable so that means a new pump. It is no small job by...

There are two Z20 engines- Z20S which is a carburated engine and the Z20E which is a fuel injected engine. I suspect that the heads fit either block and your daughters one has had a head change. From the link above Dion called bulshit. I think he is the one calling bullshit

Which weight are you referring to? The requirement for the breakaway requirement is based on the GTM and not the ATM. Vans that are 2000 kg GTM or under do not require a breakaway controller to be fitted.

Whilst the requirements for a BATTERY monitor capable of checking the battery health in the breakaway controller was written into some of the various instructions it was never included in the regulations. As it was not in the regs it was then shown that the instructions were not applicable. The...

Seriously, the wire from the brake switch is only a trigger wire, it draws very little current so the voltage drop is zilch. That is also the recommended method of wiring the brake operating trigger for any vehicle with bus control of the electrics. In those cases you have to find a place that...

The limp home mode does not control the turbo, it controls the amount of fuel fed to the cylinders.

I did nothing. For some reason the problem went away by itself.

I had that for a while. My mechanic suggested it was to do with the throttle control mechanism. Every time I experienced the problem it was the result of planting my foot to exit a corner or make a run at an upward slope. The explanation of the problem goes this way. The throttle position...

I have had a look at the Narva site that I gave the link for and can not see how you can overcome the reversing sensor problem you are having. The only thing I can suggest is that you refit your connectors with the 12 pin connectors if you really wish to overcome the problem. If you look at the...

Where did this 13 pin plug come from, was it this one? the normal one has 12 pins. If it was a 12 pin one, there are several 12 pin sockets, view this link. 12 Pin Flat Plug/Socket Did your friend use Part No. 82072BL or did he use one of those with a reed switch. You need the appropriate...

That is because the lenses of vehicle lights are designed around a light source of a defined size. If you exchange the globe with another of a different size the optics do not operate as designed. The replacement globes for all the common filament lamps used in vehicles are specified in...

If you put a bigger turbo n, will the wastegate just start to dump the extra air a bit earlier? What is a bigger turbo boing to achieve.

I would not be using wheels that do not fit the hub properly. That locating ring on the hub that the wheel centre fits neatly over is there for a purpose. You are asking for trouble if the wheel does not fit snuggly on it. Have a close look around the wheels, most of the Sunraysia style wheels...

That looks like a real dogs breakfast. It is far from being standard. When you say "Raw End" does that mean the wires just go nowhere? The bunch of 5 and bunch of 3, does the raw end apply to all the ends. If these look like they have been cut and left swinging, is there some wires looped back...