After the Dual Mass Flywheel gave way on Fraser Island on New Years Eve this year and subsequent massive recovery journey behind the back of Landcruiser Tractor. New Solid Flywheel and Heavy Duty Clutch in Hervey Bay cost $2,300. Would have been cheaper in Brisbane with quotes around $1,900...
Sorted - Costly Mistake at Fuel Pump
Thanks Kernels and Old Tony for your advice. However, all the advice in the world can't account for stupidity.
It turns out I topped up the tank with unleaded according to my Nissan dealer. I could not believe I would make such a mistake and went through...
Funnily enough I tried that at my brothers place, took 6 times to gain pressure after the drive back.
It has been sitting outside my place for a couple of hours and would not start. It took 10 or 11 pumps to get pressure this time but started immediately pressure was present.
It is...
I hope someone to help. My 2010 Thai D40 developed a starting problem on Saturday. This is a bit long but it may give a clue.
I filled up on the way way to long weekend camping trip and drove about 60kms without issue. Pulled up and stopped for about 20 minutes while waiting for the rest of...
Bathurst is great and I am returning this year with a dozen like minded mates. This will be our 4th trip.
The first was in 2006 where our eyes were opened to the wild events on the top of the mountain. We backed up in 2007 where the mountain folk remained defiant of the updated police...
Thanks for your help Robert.
The Chip It Dominator Mk1 and EGR blanking plate arrived last week.
Easy installation. The change in power delivery has certainly improved the driving experience.
Thanks, they are M12 with a fine thread. The same size bolts that are used to fix the towbar. I can't remember the exact thread pitch but the bolts have 8.8 stamped on them (see attached).
Hi,
I am new to this forum so have not worked my way around the site extensively.
I have just purchased a 2010 RX and managed to get a good original Chrome Bumper off a STX. The bumper did not have any bolts. Can anyone tell me what bolt size is required and whether they are high tensile...