Recent content by Steve Berry

Hello i,m trying to find an ignition sorce for my DCDC charger any one done this before cheers steve

Any one know what diff is in a Stx550 it not a limited slip diff but seems to drive both wheels when in a muddy position

I brought the bits of mann filters except for the joiners got then of ebay you need 3 joiners 2 for at the provent end 1 to join the pipe from the pcv elbow hope this helps you can ring me 0411795190

Ill check the pipe size tomorrow and take a pic where i mounted the provent the pipe was 16mm i think it took me a while but could be done in 2 with making the bracket for the provent as well

Its much the same what i did was turn the factory pipe thats from pcv to engine around and use a joiner to conect to the pie that runs to the provent and the other pipe strait from the engine to the provent just make sure you conect the pipes the right way around

How old are you im 64 and did mine last year could go any where so did it took me about 5 hours because had never done one before

Ok im in melbourne do you have any mechanical knowledge or do you have a mate with some

Hi WAS550 where are you located ,It is a bit of a tricky job but can be done

Thanks for the info mate now i know i have the right pipe ill get into it cheers steve

The hose is not the same size the outlets on the catch can are 25mm

Thank you Amber.2 but Provent dont do a kit for the STX550 HPD do but the replace the PCV valve with there own unit and a 19mm fitting i am hoping to hear from someone who fitted a catch can using original components and that would know what size inside dia the pipe that runs from the PCV valve...

Hello every one i,m am going to fit a catch can to my STX550 and want to have all the bits ready before i start. Have the provent 200 can am hoping some one can tell what size pipe is on the pcv valve have conflicting information some say 5/8 (16mm) and some say 3/4 (19mm) i know its a bit of a...