Recent content by SirDelton

Hi all, I believe I have all the parts available but at this time I have no plans to rebuild. Pistons, head gaskets crank seals and head stem seals have all been purchase. Big and small end bearings are available and will be ordered once crank and block machinING is done. All parts are...

No idea till it’s out.. but why can’t they be machined.. Allothers can

Found pistons,seals, head gaskets valve steam seals.. so if you look you can find all parts to rebuild

Just got this back from ACL bearings who I have always used for race engines. So bearings are ok.. Head gaskets seem available.. Pistons are the next to track down

So what did you end up doing? Scrap it or retro fit a different engine?

Looking for a service exchange engine

Hi all, Looks like my engine has expired so a rebuild is needed.. Is there a good manual for rebuilding the engine? Most online that I can find are for service and diagnostic problems. please send me a link to [email protected] Also looking for a rebuild kit for the V9X or someone in...

I'm getting the P012B fault on my Navara STX550 (V9X) I have replaced the sensor on the Intercooler (Also New). The car seems to make good power but then going into limp mode. You can turn off the key and back on again and it will go back to having good power until it goes back to Limp mode...

Sorry to hi Jack this post.. I'm getting the P012B fault on my Navara STX550 (V9X) I have replaced the sensor on the Intercooler (Also New). The car seems to make good power but then going into limp mode. You can turn off the key and back on again and it will go back to having good power until...