Recent content by OzD40

In Queensland that light would be legal but wind dynamics would be disrupted as others have stated. Not sure about the amount of light flare on the bonnet etc.. A light bar on the top rail of bull bars is another matter...

Bloody frustrating that’s for sure. At Easter during the lockdown I removed the inlet manifold and degunged it, fitted blanking plate and ProVent 200 catch can, changed brake fluid and coolant. I was bored 😐 One thing I did find when I was knee deep in the engine bay was a couple of hoses that...

Likely the boost control solenoid. Don’t mix up the 3 pipes either

Spanish or Thai?

I have the same vehicle and issue. Found this on another page and now perform it after every oil change. Resetting ECU and FUEL pump MAY help in cutting down on that horrible tapping noise that the D40 suffers from. Also removes limp mode I’ve carried out this reset and the engine is alot...

Yes. Better late than never. I fitted my 2010 D40 @ 235k kms after decontaminating the inlet manifold. Less smoke and slight improvement in mpg. (y)

I have a 2010 D40 Y25 that the dash showed a fault and was in 4low Used the dash switch several times going back and forth but display would come back. Put vehicle on a hoist and spun wheels by hand in gear. It was in 2wd contrary to dash display. Eventually replaced the three sensors on the...