Recent content by blueute

Seen pictures of what looked near identical to our 1992 Nissan Datsun ute/hardbody/truck/navara/D21 (did I miss any?) I see these cost about US$10 each if you buy 100 or search "potluck " it. I see Walmart sells them too and there's where I see the Frontier lower control arm. Anyone used a...

Hi, I'm in the process of doing the steering on the 1992 D21 (hardbody / nissan / truck / UTE) depending what website I fall down and have come across several "aftermarket" parts manufacturers and since Nissan has JS left, I'm wondering which aftermarket brands to avoid and what are the ones to...

Try a 2nd Key Fob if you have one, You did check the fuse? If thats good, I'd get something like a rubber mallet to give the door frame by the lock a gentle tapping whilst using the key fob You could take off the door cards and see if there's anything odd if the temp is lower than 25, use a...

FIXED ! problem was slightly misaligned inner plate, sorry don't know the technical name as there no manual for this but it is easy to misalign as this plate can spin so easy when gooped up with lube for assembly. Just make sure theres one pin holding each part in correct orientation during...

Thanks thanks , appreciate that.

Nissan D21 92 Hardbody Utes Summer break, long over due maintenance of front wheel bearings, engine / radiator / PS flush and clean) So, PS, Replaced gaskets and seals , reinstalled , bleed system according to Haynes manual but now PS seems to be not working fully. Seems OK for first part of...

just got it out and look ok Doesn't have any bad burnt out smell, and the bench test confirms that the solenoid is working ok but no armature movement, ?? how do you test that?? I have the + from jumper to the + post on the starter, the - jumper to the vice it clamped in and I have a spade plug...

thanks for that, will have a look now, if I dont see anything , going to pull it out and check it.

Starter works perfect but on the occasional day decides not to. All I hear is the solenoid pushing the cog ("click") in but the starter fails... then turn again and it works perfectly. has new battery and new alt. just put in new starter brushes 3 weeks prior and only now showing problems...