grumpy too
Member
Having an issue with the ABS light on my 2009 D22 Have now tested all the pins on the actuator and they seem to be what I would expect from the wiring diagram, the garage doing a roadworthy apparently got rid of the light but it came back on and it doesn't show any faults all sensors including the G sensor seem ok.
I did swap the ECU from the 2008 car I got the motor out of to save programming the injectors but even though they did do an ABS change between late 2008 (JNI) and 2009 (MNT) the wiring to the G sensor on both of these only have 2 wires not 4 as the later models, I can't see any connection to the ECU anyway but there are 3 wires to the data link connector.
If there is air in one of the lines can this bring the light on? will bleed the brakes tomorrow anyway, not really fussed about the ABS not working as prefer it not working.
I did swap the ECU from the 2008 car I got the motor out of to save programming the injectors but even though they did do an ABS change between late 2008 (JNI) and 2009 (MNT) the wiring to the G sensor on both of these only have 2 wires not 4 as the later models, I can't see any connection to the ECU anyway but there are 3 wires to the data link connector.
If there is air in one of the lines can this bring the light on? will bleed the brakes tomorrow anyway, not really fussed about the ABS not working as prefer it not working.