Search results

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    Random flickering engine light

    Sorry for the long time between reporting back, work got in the way. Cleared the codes, reset them. Only 1 code came back 0905. Intake air pressure sensor. took it off, tried to clean it, had an impact, now I have a full non flickering engine light. I'm happy with that as I know it's...
  2. M

    Random flickering engine light

    Hi Tweake, thanks mate, I’ll clear the codes today, and report back. Checked earths, still really clean and tight. No second battery fitted. Would it/ could it have anything to do with me blanking the erg pipe out completely following its failure in Dec last year?
  3. M

    Random flickering engine light

    Hi all, back again with the next intriguing Navara issue. My engine light is flickering randomly, not flashing, and mostly out, but flickering often enough to make me investigate. No loss of power, in fact no impact on performance that I can find at all. Pulled the codes: 0703 - injection...
  4. M

    Power loss, metal on metal sound that drops to a tinge on idle

    Hi Tony, as usual you were spot on. I think you may be a Navara whisperer. I just wish I’d seen your post earlier, it took me about an hour to find it. ERG tube had blown its weld at the exhaust end. Given my need for the vehicle, and my inability to locate a new tube quickly, I went for the...
  5. M

    Power loss, metal on metal sound that drops to a tinge on idle

    Hi all I’m back, I was driving the old girl down the road, gently changing up 3 to 4, weird sound like a fan failure, loss of power, crazy metal on metal sound and the exhaust sounds like it’s fallen off but hasn’t. No smoke, idles fine just a metal ting, ting sound that I cannot pinpoint except...
  6. M

    Overheating problem

    Not quite that long, but once i had replaced the head with the one that didn't work, I then had to go thought all possibilities, and i could really only spend time on it over the weekends. Once i got the new head, it was literally one days work to remove the original cracked head, and replace...
  7. M

    Overheating problem

    They are 10mm bolts, I used a 1/4 inch Sidchrome drive, with its long extension. They are not tensioned super tight, and I was able to get enough purchase just with this set up. The second time I did it, I added in one of those multi angle 1/4 inch bits, it made the job even easier. There is...
  8. M

    Aggggghhhh TDC No 1 cylinder

    So to close my own post. Well, ill start with, i am pretty sure there is a Navara engineering laughing somewhere at all of us who attempt this herculean feat. That said, i will now explain why it is so hard to actually set TDC using this process, and also what i ended up doing to solve my...
  9. M

    ZD30, new head install, cranks, doesn't start.

    Brilliant good to see it sorted, and that's the same team i got my good head from, i've put on over 5000 km with the Mr Cylinder head, she is running beautifully.
  10. M

    ZD30, new head install, cranks, doesn't start.

    So i had a very similar problem, and solved it in the same way you have so far, i eventually removed the gear cover, (which i got very good at). I put on a 'new head' and it simply didn't work, it would crank till the cows come home. Eventually after trying multiple different things, earths...
  11. M

    Replacing - Rear Leaf Springs and Shocks

    Hi All, Just looking for some ideas and brands that people know work. I'm going to be replacing the rear springs with a new set as my old ones have done their dash. I don't really want to raise the ute any higher than it is, however i realise that every set of new springs seems to raise it...
  12. M

    D22 fault code 0301 engine cranks and will not start

    So this is the final part of this thread, as you can see above I had a cracked head, replaced it and the car wouldn’t start. I scrubbed the earths to super clean, I replaced the starter, I was getting really good fuel at the injectors, it was killing me. I was learning a lot however. I have...
  13. M

    D22 fault code 0301 engine cranks and will not start

    Hi Boogieboots, I’m jumping the plug at the moment. And yes, it would really only just turn over a few revolutions on Aerostart and then die. I’ll see if I can get enough out of it to watch the tacho. Thanks
  14. M

    D22 fault code 0301 engine cranks and will not start

    Hi All, again thanks for the advice and thoughts, I’ve checked all the earths I can find, cleaned them all up, removed paint, checked for resistant and renewed if any. Unfortunately still nothing. I have to say that electronic diagnostics are not a strong set of mine. Is there a simple way to...
  15. M

    D22 fault code 0301 engine cranks and will not start

    Oh and one more strange thing i noticed following me changing the ECU, pick up, the tacho, still jumps on crank, but not as much and it will settle during crank then start jumping again??? does this give any clues as to what im dealing with
  16. M

    D22 fault code 0301 engine cranks and will not start

    Hi all, Id love to say the new ECU fixed my problem, it did get rid of the 0301 fault code, and the flashing engine light. It did not get rid of the crank, but will not start... I have no fault codes, i get 0505, which i have read on these pages means no faults. Does any one have a good...
  17. M

    Check engine light

    Hi Choppahtu, To put it mildly, I’m no expert, but 0707 is the post converter O2 sensor, with a slow response fault.
  18. M

    D22 fault code 0301 engine cranks and will not start

    Beautiful, thanks Tweak’e, I’ll get hold of an ECU and plug it in 😊
  19. M

    D22 fault code 0301 engine cranks and will not start

    Thanks Tweak’e, Appreciate the fast response, I have not pulled the injector yet, so I just won’t. A few other questions though, I know the zd30 ECU is pretty simple, but if I replace the ECU, do I need to also replace other items the rely on getting a signal from that Ecu? Reason I ask, my...
  20. M

    D22 fault code 0301 engine cranks and will not start

    Hi All, Ok so firstly a huge thanks to all those who put time and effort into this forum, I have been able to do so much with the information from people on this site. So long story short. D22 running well, but… cracked head, and the engine light flashing occasionally when you turn the key...
Back
Top