Search results

Hi guys, 2008 nissan yd25 diesel I did a service new oil, air filter etc Fuel filter is 10k old Did and injector purge a few months ago And I had the diesel return line that comes out the side of the cylinder head leaking oil so I tightened the nut on it which is not the right one for it and...

Hey guys I have a 2009 r51 navara I lifted 2” with shocks and springs, the front positive camber is off and has made the 2 front tires wear fast they were almost new 1000ks ago and I have changed them already, has anyone put offset bushings on the upper control arms to fix this ? And if so any...

Hi i have a 2009 yd25 r51 210ks rebuilt engine I had a problem with the boost solinoid after the rebuild I bought a cheap one and didn’t fix the problem I was still getting low boost I bought a Nissan one and it fixed it I’m getting 15psi normal and 20 at full. car drove good for a while I was...

hi i rebuilt my yd25 i didnt have the car before the rebuid so i don't know how it drove i get upto 5 to 10 psi and it cuts out straight away, i bought a new solinoid put that on it didnt help, i changed all the lines still nothing i switched the solinoid lines the vac and the one that...

Does anyone know the wiring diagram for a 2009 Spanish I looked everywhere can’t find anything 20 pin connector ?

Are the d22 and the d40 diesel oil coolers the same online they look the same but are sold differently and the d22 ones are cheaper?

Just put back the engine after I rebuilt it its a 2009 yd25 bought it with a cracked head didn’t run, after fixing it had a few problems with boost pressure, fixed that then I noticed oil in the radiator, then there is coolant in the oil as well, I took the hoses off the oil cooler and used air...

I have a 2009 pathfinder diesel I just finished rebuilding the engine and put it back in, I have not driven in this car before as I bought it not working, I don’t know if it’s just not knowing the car but it feels a bit slow and struggles a bit uphill, the diesel injectors looked pretty dirty...

just about to put my yd25 back together and I noticed I didn’t check which way the connecting rod goes in before taking the pistons off, anyone know how to know which way they go in ? thanks

I just finished up my vq40 d40 and bought a yd25 d40 auto with a blown head gasket or cracked head, the engine only turns half way by hand then stops, car has been sitting for a while, I took the injectors out and turned still the same, then I took the cams off and still the same, what could it...

Nissan vq40 v6 New piston rings Honed cylinders New bearings New thrust washers I know it is normal for some metal during the break in but this looks like allot I used allot of assembly lube during the rebuild I know that can cause this in the oil but I don’t know anyone rebuilt an engine...

My 4.0l 2006 navara is surging It idles at 2500 and surfers up and down goes dow to 1000 when warm, cleaned throttle body mad sensor and checked for vaccine leaks nothing did the reset nothing any help? Thanks