Search results

Will give the injector cleaner ago, no signs of leaks all fuel line hoses are dry, may wipe them all down to clean them and see if any are aging

I have a 2008 yd25, engine mods are 3inch exhaust, catch can, egr blank. These mods have been on the car for a while. So the car runs, starts well when it’s cold, runs and drives fine, but if i stall it or shut it off and try and turn it back on within 20 seconds the car starts and then stalls...

So I mounted up my 3 inch exhaust from DEA, couple little problems and wondering if any one else has come across them, firstly the piece that comes off the dump pipe is touching the front tail shaft and won’t be able to turn when in 4wd due to the uni joint turning, secondly a peice of the...

Having trouble with power loss which has only just started, so nothing has been touched or services since this has started, I’ve got the yd25 d22 and the car runs perfect in 2wd, but when it goes into 4 low it tends to lose power at random there is no pattern to it, it won’t go over 2000rpm...

Ended up going with the Fulcrum seemed good valued, did spend a little bit more and went the heavy duty torsion bar. Bought the 50mm lift but lifted the car 35mm. So far pretty happy with it all

I’m looking to upgrade my standard suspension to a 2inch lift. I’m in between tough dog and fulcrum suspension, both have good reviews and are similar priced. Any feed back would be Appreciated. Weight wise it is stock with the exception of a steel bullbar and winch

So I have a 2008 D22 2.5ltr Nav that my son and I have fixed up and got on the road for his first car, we have noticed the speedo is out quite a bit, the car is stock standers. When the speedo says 60km we are doing 53km and this is a gps speed and dash cam speed, when we are doing 70km on the...

I’m not sure if I missed what motor it was or didn’t read the posts properly, injector seals do leak oil I have done mine when I did a full rebuild on the yd25, Nissan do not sell them as spare part but had them in my rebuild kit, so I went to change them and cracked the plastic rocker cover...

That’s one thing I didn’t do when it was all apart was take a pic I was to excited that I had found it, after you take the grill off on the passenger side from around the wiper, you will see direct above the air port is a plastic socket if you like, to catch the clip from the grill, mine looked...

Hi All, I have a stock D22 yd25 2008, got it for my some so we can 4wd together, the build up has started, as it only came with a plastic front bumper we decided to ditch that, picked up a second hand factory bullbar, it has the indicators and park lights in it, do I need to splice into the...

cheers mate, you put me on the right track, so it wasn’t rust, right above the air in port is a gromet that holds the plastic clip from the grill that sits around the wipers, this was no longer water tight, a bit of silicon and all sorted

Cheers, will give that a go

Will give that a go, thank you. Silly question where would the outlet normally sit, against the chassis somewhere ?

Hi all, I have a 2008 D22 Navara that gets slightly wet carpet on the passenger front floor when it rains, so put it in the drive today have it a good soaking with the hose and nothing, check it again and it was slightly wet, so my mind is thinking it’s pooling up somewhere then working it’s way...

So a bit of a update, not to sure what’s happened but car seems a little better, car will start and idle ok now, give it a few revs up to 4000 and then it dies, starts up again fine idles ok give it just a little rev and it’s starts idle real rough, so I pump the fuel filter and comes good, stop...

I have the yd 25 motor, cars seem to start ok but then in can stall straight away like the key has been turned off, then you can start it again all seems fine, give it a rev and all is on but then to give it another rev it revs very slowly and might not even pass 1200 rpm, put it a brand new...

Should have mentioned it is a yd 25, cheers

Hi there, I’ve done a motor rebuild over the last 12 months and it’s got me buggered where this bracket goes, and help would be great

Hi all, I’ve just done a motor rebuild on my yd25 d22, started it up to find the rear main is leaking even though it was replaced, so my question is, is it easier to remove the engine again and is removing the gear box a easier option ? Reason I ask is I had mine out of my gu patrol and had to...