Search results

Sorry for the delay in response. Tested all and everything is ok, except the pressure regulator on rear axle seems to have a slight leak. Car is braking much better after changing front pads and reZ shoes, but still not perfect. Will keep updated when I decide it's worth spending more money on a...

Actually it is the load sensing valve. Am wondering if any others have had issues with this.

Have had the issue of my brake pedal depressing too far for quite a while. Checked whole system and seems everything is fine. Have serviced all brakes (front caliber was seized), changed fluid, and checked/scanned ABS. I was thinking there must be an air leak somewhere, but have check and can't...

Thanks for the advice. I have checked the above and all seems fine. I have also noticed that the gearstick heat shield was not installed correctly and boot had come off. I have repaired al this and even taped up any areas that could allow heat / noise ingress. However, I am still getting issue...

Thanks all for your responses to this post. All was going well until my most recent long trip. Gearbox seems to be overheating during longer drives at medium speed, as can feel heat thrpugh gearshift and hand brake area. Quite concerning as I am a long way from home and need the car to complete...

Thanks for all your responses. I have checked the transmission oil and the mechanic who changed the blown clutches under warranty did not change the transmission fluid as it came out milky brown and foamy. Since I have changed this the transmission is working much better. Oil used was Penrite...

Agreed and do not use them anymore for the more major work. do anything that doesn't require a workshop or specialist tolls myself anyway, but had to return to them to be covered under warranty. They have stuffed this up twice before and seem to have done it again. With a few more days driving...

Unfortunately it is constant.

The clutch originally started slipping but have only owned the car since 80,000 and I suspect it was not driven well before then ass I am pretty light footed on clutches.

It is the same shop. They are Diesel specialists and I have suggested this but will follow up further.

Hi all, I have a strange issue after new clutch installed. All is working quite well after reverting back to regular clutch. I had two hd clutches blow up on me in two years due to no apparent reason except that they never sounded or shifted quite right. With the new clutch all works ok except...

Hi all, I have an ongoing issue with this leak. The gasket has been replaced twice and still has a slow leak. Oil is noticeable on the surrounding area and eventually pools in my bash plate and leaks onto ground. My main issue is my driveway is covered in oil and I'm not too keen to leave oil...

Just had exactly same issue and was blocked radiator. According to Natrad these engine will run until high speed up hills with pretty much no radiator. Mine was 80% blocked in core and external and it still ran fine except had all the same issues you are experiencing. Good luck but almost...

If you're still looking i've got one for $100 plus shipping. Good shape as just had needed elastic replaced.

I have removed my door trim as my factory speaker has finally died. During this process I have broken one of the clips on front bottom part of panel. Not so bad but would like to repair at some point. Only problem is I have not managed to source a replacement clip. I also need a couple for wheel...

This is This is not for YD25 4WD though. I believe they have a different gearbox. Also better to upgrade to a heavier duty box while you are at it especially if you tow as the factory ones are not the best for this.

These are really hard to find. You can get rubber ones at Bursons that fit and will pass rego even though a bit shorter. Probably not an issue in Qld though. They actually look really good too.

Thanks. Will try that size.

I have the yd25 so not sure this will work.

Unfortunately I am not after oil sump drain plug as I know the size of this already and is easy to source.. Am looking for retaining bolts as will likely have to helicoil now it is stripped. Am hoping bolt is stripped and not hole but this is doubtful based on past experience.