Search results

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. bods

    EGR question

    D22 yd25 won't throw engine codes with the egr blocked. It hasn't got a flow sensor in it, my 2010 was blocked from around 7000km and I sold it with about 125k km on it and never had an engine light or any codes at all, let alone egr. As for the turbo timer, all they do is allow the engine to...
  2. bods

    Tray or Tub?

    The thai built models had a 100mm longer tub, that's the difference with them. Physically they will fit, but as I said, the towbar sits too far under if you have a rear step fitted. I'm not sure if they went back to the shorter tub when they moved back to Japan for a year or 2 after the floods...
  3. bods

    Tray or Tub?

    Hey mate, you could get a canopy for your tray instead, but it depends how you want to set it up. If you want to change to a tub, the 2015 may fit. I know they did have issues in thailand around 2011/2012 and moved manufacturing back to Japan for a while, but I don't know if the tubs stayed the...
  4. bods

    Knuckle assembly wont come off

    If you've got a blowtorch or one of those smaller butane torches that plumbers and that use, try heating up the metal on the spindle a round where the ball joint goes through to expand it a bit and you should be able to crack it free. You may need to try that and some freeze spray on the ball...
  5. bods

    Automatic hubs wont fit

    I don't understand why you'd bother with auto hubs on a d22 anyway. Single cab 4wds had permanently locked front hubs (basically a hub cap with splines that bolted to the hub face). If you want to use 4wd without getting out, just leave them locked in. Manual hubs are awesome for low speed...
  6. bods

    Vibration

    All good, let us know how you get on.
  7. bods

    3 inch exhaust questions

    If you're worried about the legalities, get a cat and no muffler it will quieten it down a bit anyway. I had an xforce on my yd25. Originally with just a muffler. It was really quiet, so I cut the muffler out and put a straight section of pipe in. It wasn't overly loud, not really any drone...
  8. bods

    Vibration

    I had an xforce on mine. It was 3" but the back of the dump pipe was bashed in a bit before painting (by them, not me) so on my 2010 it had a fair bit of room to the firewall. The stud mine was hitting was almost right under the passenger seat. Easiest way to check is lay under there and run...
  9. bods

    High idle fuel pressure D22 navara yd25

    The thing that makes it seem worse is having the solid flywheel in them. The good thing is it can handle a bit of slippage without too much issue. When I had to do tight maneuvers or reversing uphill, etc I just put the transfer into 4lo with the front hubs unlocked and it is a lot easier as it...
  10. bods

    Vibration

    Unless the exhaust is touching something I wouldn't be too worried. When I first fitted mine it had a clunk when moving off from a stop, turned out it was way too close to one of the studs that holds the heat shield on under the cab on the left side. I cut it off flush with the nut and never had...
  11. bods

    OIL PRESSURE GUAGE

    Hey mate, I had one fitted to mine. Used a 1/8" brass nipple and brass t piece for the factory switch and the sending unit for the gauge. I fitted a saas gauge, but the sending unit thread should be the same whatever the gauge, although they are a 1/8" npt thread, they are pretty close. I never...
  12. bods

    High idle fuel pressure D22 navara yd25

    Mine used to to that too, pretty sure it's a standard ecu program thing. Whether it is to do with a certain idle map in the ecu I couldn't say, but didn't matter if in neutral or in gear it would do the same thing. Same if you engage the clutch a bit too hard and labour the motor slightly at...
  13. bods

    ZD30DDT FLYWHEEL?

    I think you'll find it is a problem with the gearbox if it is slipping out of gear. Nothing to do with the clutch, although as you said it wouldn't hurt to do it while you've got the gearbox out. D22s all had solid flywheels, the zd30 in the patrol has a dual mass unit. Just get yours skimmed...
  14. bods

    Clunking noise when first pulling away

    It could be driveline backlash. Is it any worse if you go backwards and then forwards again? If you've got somewhere flat you can try it out. If you're not sure of the service history or even for your own piece of mind it wouldn't hurt to change the driveline oils. The colour and texture of the...
  15. bods

    Clunking noise when first pulling away

    First question is auto or manual? If auto, are you parked on a slope when it does it and does it only do it moving from park to another gear? If not, refer to the post above, but if it does it on a slope, try putting the transmission in neutral and applying the park brake and let the vehicle...
  16. bods

    New D22 owner

    I know what you mean. The main reason I did them was because the rear lights are a pain to get out, especially with a tub liner in, so being led they tend to last a lot longer than the filament ones, so not pulling stuff apart as often is awesome lol.
  17. bods

    SLIDERS AND BARS (who is interested)

    Considering this thread is 4 years old and scottybobcat hasn't been on the forums since Dec 2018, I don't like your chances. But you never know I guess...
  18. bods

    New D22 owner

    Good stuff. If you replace the indicators with leds (I did it to mine) jaycar sell a japanese spec 3 pin led flasher relay for about $15. I got one for mine off eBay years ago now and never had a drama but still paid around that anyway. I used the jw speaker led replacement globes (eventually...
  19. bods

    Android CD player/GPS etc

    The main thing you will find is, the cheap ebay ones usually have an Android operating system in them. These are not bad in that generally whatever apps run on an android phone will run on the head unit. Usually you can do updates and download apps and stuff through a hotspot on your phone or...
  20. bods

    New D22 owner

    They should fit standard height. Factory alloy wheels are 16x8" with a pos40 offset. The wheels he's said he's using are a 16x8" with a pos20 offset. This means the wheels will sit 20mm further out from the hub face towards the outside of the vehicle. The only issue you may have with stock...
Back
Top