Search results

i purchased sunyee break away system has 3 wires ,black blue white , wired in with redarc electric brake system. on testing the break away system i noticed the brakes engage on the tandem, but the stop lights dont come on when i pulled the switch wire.. scratched me head for a while then i...

while i apply brakes blue & or green light changes to red.. Voltage drop?? do i need to upgrade earth wire. The brakes only come on lightly even when i choose manual and dial to 10 Max

if its still under warrany get an opinion off different dealer workshop.. or take it to independent brake and clutch service and get a diagnosis.When i first learnt to drive i picked up my old mans habit of resting me foot on clutch pedal ,soon got out of that habit when i had to replace clutch

my old g60 did this it was a stripped big end..yours with maybe cracked piston. with my old zephyr it only rattled when you took the foot off the gas but.. could be something else try listening device, garden hose start at ichain over the top and down each side of block

bac to the past with the late 90 navaras people would have their inj pumps recalibrated to try and give them a bit more grunt ,if they were opened up to much they had serious black smoke issues ,

i upgraded my rear coils 50mm lift , used tough dog adjustable shocks still would sag with load , had to fit airbags to maintain my towbar at proper height for towing , now feel every bump, have got used to it

not sure if this will help, i run my hose over the top of the rocker cover so that someof the oil that accumulates in the hose,runs back into the motor, i still catch some oil but not excess amount.

getting conned i was told by my mazda dealer that i need new tyres only done 36000 klms because of some tow in adjustment , if the tyre swaps happens every 10th klms you wouldn't notice, the tyre tread has plenty of depth, the edges still have depth .i will get an alignment done ,from my...

had a car which would shudder and run rough at certain revs , was broken engine mount, could never figure that one out

general procedure for diesel engine..the fuel would not have reached the injectors you would stuff up the inj pump first. my 2015 np300 has elect fuel pump. disconnect delivery to fuel filter , also at fuel pump, at injectors ,and return line at tank. turn ign to run pump you will hear it...

some info on vegetable oils.... In 2000, Houghton International formulated a fire-resistant vegetable oil hydraulic fluid – Cosmolubric B-230. This technology made it affordable for manufacturers to switch to a biodegradable, oil-based, fire-resistant fluid without compromising performance...

the electronic mechanism that operates that flap gave me a lot of grief on a previous car ,the plastic segment gear would loose a tooth causing the flap to behave irrationally, car would go into limp mode , disconnected the power supply to it and car ran normal, until i got a replacement part

with one of my cars it was brocken plastic connector part of the actuating mechanism at the lock. if its central locking try puting power to the solonoid and see if it moves

2016 post on forum ...........had this exact code and my pump was terminated. The pump has printed circuit board built into it. Usually this code is the pcb starting to fail. Unfortunately, the pcb is not a thing that can be replaced too.(Try clearing the code you may get one start out of it)

yes some free play is needed to stop bearing making contact and prematurely wearing out

if the primer doesnt hold hard it would have to be sucking air between primer and tank and or blocked line?? codes may be by product of fuel supply

try getting a fault code and check for fuel air in fuel lines

vacuum lines on wrong ports???

as explained by another member the problem with d22 (mine is 3.2 ltr diesel )is that they were indirect injection which means that the fuel & injection happens in a small chamber in the head its an original idea which was out dated in the 60's. the direct injecion system eliminated small...