Search results

Hello everyone, a question would I need to place a spacer between the rear diff and the driveshaft after doing a suspension lift with the used of add-a-leaf spring or is the angle of center bearing because of the lift causing it to flog out. Center Bearings not lasting long on the truck.

hello has anyone consider the option of using heim joints instead on ball joints for D22 Frontier.

hello to everyone,was looking around the engine to see how i can get a oil drain for my provent 150 catch can,this bung is right under the oil cooler housing,high lighted in red,haven't undo it yet,but do you think that it is an oil drain hole.

hello to all,has anyone every change out the wire pigtail or the plug coming from the main wire harness of the zd30 boost sensor,wiring is brittle and connections inside the plug,would like to get a new plug.splice into the wire harness and be done with the breakage.

hello to all,anyone know of part number for the roof rails rubber inserts for frontier d22.

hello to all,can one shed any light on this problem,qd32 gives a run off after turning off the engine,i have taken off the intake pipe and used my hand to cut the air being drawn by the engine,with this action the engine shuts down smoothly,fuel cut solenoid is a pain to get to,thinking that it...

hello,how can i wire in a manual over switch for my water to air radiator's cooling fan,i have a thermal switch but would like to put in one.

hello to all,can i do this mod without installing a lift pump,did a temperature test of the return line from the pump at idle and got average temperature of 60 c,want to connect the spill to the return side of the pump and add a cooler to the line before it goes back to the tank,yes i know ppl...

hello to all,i am having a problem with zd30,intermittent of the main butterfly,sometimes when i turn off the engine,it shuts down smoothly,other times rough,i have check the manual and followed the process of troubling shooting the cause,the ecm relay is good,the connections,the vacuum...

not sure if there is topic with this heading,but here goes,was pushing the zd30 hard,not a full fogging,turbo blew,meaning the intake side of when,shaft snap,the engine die as well,when i went to start back,it wouldn't,check fuses,did a code read,nothing,compression test,#1 was 200 psi,manual...

as the topic says,what is the size of the box,meaning the outside diameter,height and what size filter goes into as well,may have to built my own,no scrap yards in the caribbean that i can walk in or get one shipped to me,i work at a fabrication shop so material and machinery to make it wouldn't...

k,looking to uprate my shocks for the d22,stock height.can i used the rancho rs5188,front as well the 5116 for the rear.the websites say that u have to used them with a lift kit.the mounting of the shocks are both eyelets.can't seem to find any bilstein as yet for it.

hi everyone,i see that the YD25DDTi has in a fuel cooler for it engine,what are thoughts on putting in one similar for the zd30.

hello to all,i am new to the forum,i once had a land rover defender td5 but lost that in an accident.now have a nissan frontier d30 2004 model.just did a fuel filter change,looking to do egr blanking business this week.