Search results

Hi, giving an update, I have changed the cross by the gearbox, the vibration has being reduced, however it seems to come back as i drive, still feeling it by the floor, will looked to get the center bearing changed, since it seems to more localized in that area now, I made a looked at the front...

Hi, i am putting it down for a bad universal joint, sometimes the vibration is there and sometimes it isn't, feeling it right by floor, like when the center bearing is bad and as i said before the universal is the one that isn't moving as free as the ours, just waiting for the parts stores to open.

I thank you for the advice, the lift was done almost 4 years ago, I did do my research before I did any work on the truck. Centre bearings weren't lasting, these past 2 years. Will looked to get one of the inclinometer and see what the angles are. Will get the genuine center bearing and the 1st...

hi, have being using aftermarket center bearing, this is the last one being put in, i have taking out the rear drive shaft and inspected it, the first cross by the gearbox isn't moving as smooth as the 2 others, i will change that out and see how it goes.

since i had the truck, i had only change 1 of the crosses, will checked the other two on the driveshaft, thanks

the lift is standard 2" via an add-a -leaf, i took looked at it this morning, not remove for a spacer, i took off the drive shaft to see if there is float, none, will continue to checked the drive, going to checked the gearbox mounts, etc. thanks for the reply

Hello everyone, a question would I need to place a spacer between the rear diff and the driveshaft after doing a suspension lift with the used of add-a-leaf spring or is the angle of center bearing because of the lift causing it to flog out. Center Bearings not lasting long on the truck.

Here is the part # 119168J000

Ok here is some info.

Yes Ben_W,it is working great,will posted the readings of the manual in reference to the sensors,going thru the manual to find them.

Thanks Ben_W

Hello to all,how do you setup a log on the ecutalk,it says to click on the sensors you want to log twice,but once i do that nothing else happens

It is located on the alloy pipe,the bottom hose,which is bolted to the block.

Ah ok so just get better tie set up,thanks.

hello has anyone consider the option of using heim joints instead on ball joints for D22 Frontier.

Hello to all,mines is reading 52 inj timing c/v %

I just got the cable as well,loving it,next project is cool the fuel to a reasonable temperature.

i have tried to order from them,no luck,keep getting an error from they site,have sent an email to them,no reply back as yet.

Following this thread,i am also looking for such an item.

http://www.baileysdiesel.com/shop/zexel-injector-to-suit-nissan-48-4120-vz-zd30-3ltr/