Recent content by tane

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. T

    Engine blow up

    Nah, that's why it's weird, it was running fine with the same power until then, I was thinking what your saying but can I be that unlucky
  2. T

    Engine blow up

    Just trying to understand whats was gone wrong but not 100%. I was driving on the highway when it started losing power then it lost all power and was maked some shit noises and poured out black smoke. After doing a compression test, cylinders 1 and 2 had no compression, so made the call to pull...
  3. T

    D40 Enters a Sort of Limp Mode When Starting Sometimes

    thanks so much for the reply, just to clear some information i missed. The EGR is already blocked off so it won't be that. I have check all the vacuum hose to the turbo and controller and they look in good condition, but might change them to be save, but it might boost controller is being stupid...
  4. T

    D40 Enters a Sort of Limp Mode When Starting Sometimes

    I have a 2007 d40 and some mornings on initial start up it will enter some type of limp mode or over fuelling and won't rev past 2.5rpm, zero power up any hill and if you try it give it some, just crazy amount of black soot and nothing. But let is warm up about 2 -3 kms and it goes back to...
  5. T

    Whats the piston ring gap spec for the yd25

    thank you so much mate been stuck on this for the last couple of day, I just need to check before assembling the engine that the rings are going to work, If its not to much hassle can you just take a photo of the "pistion to cylinder wall clearance" page 273 because its looking that I might need...
  6. T

    Whats the piston ring gap spec for the yd25

    Whats the piston ring gap spec for the yd25 engine, can't seem to find the info
  7. T

    yd25 balance shaft assembly

    yea pretty much need to get the car back on the road
  8. T

    yd25 balance shaft assembly

    sounds good bro can you find out how much to ship it to shellharbour, nsw
  9. T

    yd25 balance shaft assembly

    I need to know if it is possible to buy the to front gears on the balance shaft assembly of the yd25 because the engine had big end bearing failure cause metal piece to go inbetween the two gears and chip the bigger one of the two pretty badly
Back
Top