Thanks for the helpful reply! Perhaps I should just run two new wires from the sender to the tach? It's very hard to follow the tach wires from source to tach because they split off and run through a loom with other wires.
Do you have any tips how to figure which two wires at the gauge...
Hi -- old thread I know -- I could use a bit more help though. My tach (TD27T tach in a TD27) is registering, but it is reading low. At idle, it is reading 0 (no signal). Once I start to accelerate the tach rises, but it never reads above 1500 RPM no matter how high I rev it.
The TD27T tach...
I ended up swapping the tach from a TD27 turbo UK Pathfinder into my TD27 nonturbo Pickup (JDM). The part numbers were exactly the same - K26061 73P03 -- but unfortunately the new tach is still not registering. It's completely dead when the truck is running.
Do I need to check the tach wire...
Hi -- do you all know if a tach from a 94 Terrano (UK model, TD27 Turbo, auto trans) could be transplanted into the cluster for a 94 Navara TD27 Nonturbo, manual trans? Visually they look the same, though I am unable to confirm precise part numbers.
I have the source and target pictured below...
I need a working tach with the same part number as shown in the screenshot. If you have a full cluster, I could use that too. This is for a TD27 non-turbo D21 (1994)
Would need it shipped to the United States.
thanks
Hi you all -- My '94 with TD27 (nonturbo) has a really jump tach. It just never reads correctly, and it starts jumping when I turn on the ignition before I even crank the engine. I took a video of it here: Video of my Jumpy Tach
I've tried tracing from the sender to the back of the engine bay...
Hi,
I am in the USA and own a 1994 D21 2.7l Diesel Crew Cab 4x4 -- it's a JDM import but mechanically I believe it is identical to a same-year Navara. Is there anyone else in the USA on here, with one of these? I was thinking we could exchange our maintenance tips in this thread, as to what...