Old.Tony's latest activity

Nissan Navara Forum

Help Support Nissan Navara Forum:

  • Old.Tony
    Old.Tony replied to the thread Nav build.
    SAS conversions have been done before, you'll probably need to get it engineered (if only for the increased height so the front axle can...
  • Old.Tony
    Old.Tony replied to the thread New Member.
    Welcome aboard. That's not a lot of mileage at all - the engine is really only just run in! :)
  • Old.Tony
    Old.Tony replied to the thread D21 engine swap.
    I haven't done this before, but a bit more information might help people - what year model is yours, what engine does it have in it at...
  • Old.Tony
    Old.Tony replied to the thread What do these wires do.
    It's an Australian ute, my guess would be the seat belt pretensioner. Have a close look around the bottom of the seat belt clip. Edit...
  • Old.Tony
    Old.Tony reacted to Big Nate's post in the thread The old “ZD30 Won’t Start” with Like Like.
    Cheer Tony, Didn't know he had a website. The last time I ordered from him it was a phone call after finding him on a Patrol forum.
  • Old.Tony
    Old.Tony reacted to Braks's post in the thread DIY EGR Delete with Like Like.
    Hey team, thought I’d share the EGR delete I just did on my Spain built YD25 D40. I opted for the full removal of the pipe so I found...
  • Old.Tony
    Their web site is still active. I guess that's a good sign! https://nizzbits.com.au/
  • Old.Tony
    Welcome aboard. The YD25 in the D40 regularly takes 20psi of boost without a drama so you could easily go that high as long as your...
  • Old.Tony
    The pipes heading up into the engine bay to the small black sensor are the pressure differential pipes. The black sensor is a hall...
  • Old.Tony
    Old.Tony replied to the thread Horn Failure 2019 NP300.
    The horn fuse is in the engine bay, in the distribution box near the battery. 15A fuse.
  • Old.Tony
    Old.Tony replied to the thread Po335 fault is kicking my butt.
    I'd have a look for magnetic interference. Had a couple of instances years ago where metallic particles were attaching themselves to the...
  • Old.Tony
    I was unaware that the 2010 ST model had a DPF, but then I'm often surprised by unexpected things (like the guy in the mirror when I'm...
  • Old.Tony
    Old.Tony replied to the thread Dipstick oil level..
    There's a hot side and a cold side (this should be stamped on the dipstick). The "hashed" range is the acceptable level range - as long...
  • Old.Tony
    Old.Tony replied to the thread ESP/ABS error.
    Hi, Seems nobody else wants to chime in on this one ... I'd check your wheel bearings. If they start to wear, grease and debris will...
  • Old.Tony
    Your car should have an intercooler (top mount, if I remember correctly). You could install an adapter on the output side of the...
Top