Recent content by Fogazi

Oh nice, good information. Was looking into one from wreckers if this didn't work but was stumped on how to re code it.

So I had this exact issue and thought I should revive this thread to potentially save some users a lot of money. The issue described is indicative (no pun) of a failure of the BCM under the steering wheel. I figured I know enough about electronics that I could open the BCM and see if there...

Well, I finally figured it out. Due to covid19 I kinda had to deal with it for a while for reasons. Anyway, it was the coolant lines that run to the heater matrix behind the passenger dash. The matrix and lines had a bit of play in them and seemingly once hot enough it began to vibrate/resonate...

It wasn't the oil. It certainly was over full though.

Here are some photos of my engine bay with cowling removed, just so you know our layouts are slightly different: https://imgur.com/gallery/vL5BdtK I have searched high and low for anything loose or missing to no avail. I did your actuator test Tony and it did the same, sucked straight in...

I did just go and have a 2nd look at the boost controller. It definitely isn't moving but I did notice when I start the engine, it sucks fully in. And when I unplug the controller, it releases fully and then goes all the way back in when I re-plug it in. Same happens when I take the vacuum line...

Hello, new to the forum. Loads of great advice here so thanks in advance. I have a 2013 D40 ST 2013 Spanish built Navara. I have this strange noise that I have recently noticed that I am sure is coming from the engine bay. It is a hard noise to describe but sort of a hum/vibrationy noise. It...