Recent content by Benengel

I did both the upper and lower ball joints the other month. For the upper ball joint i had to remove the whole upper A arm. i didn't have a press or a vise... only blocks of wood and a mallet. which was pretty difficult to say the least. The lower ball joint was piece of piss. had to to use a...

Cheers for the reply Tony. I'll buy some of the Molly purge and give that a go.

just noticed that i can pump the primer 4-6 times then 2 minutes later another 4 times and so fourth

Hey guys. My ute has been up to all sorts this last month. The ute started to surge when going up hills in 4th. Thought I was the NPS... Did the test and disconnected it and it made no difference at all. Then just last week it started to randomly cut out while driving but no quiet a stall more...

Hey Tony, looked at these before but they never seem to look right... all the ones I find seem to only go to a 2010 d22 navara.

Thanks i ended up ordering through a local nissan parts dealer as no else in nz had one and its 4weeks delivery ex Japan... Made sure not to loose anything... don't want tonspend more then I have too

This is what I have left. Excuse the photo. All the replacement parts seemed to be more of contained unit. Any ideas ?

Hey guys, when changing all my ball joints the other day we found half the roller's out of the needle bearing from the passenger side sitting in the manual hubs. Has any one replaced them and know the best place to get one ? Trying to just go OEM through nissan but its proving difficult. And...

Awesome cheers for the replies. If the shipping wasn't the same price as the set i would be getting them straight away

Hey guys looking at getting some RDA breaks/ rotors and also some drums from nav life. Does anyone know if they are any good or if they are cheap after market ones...

Hey Tony Didn't know there was a dimmer switch for a 2011 yd25 d22?

After some more googling I found that there is a few years where they have soldered in led lights which I assume I have. Has any one got there's replaced as they are getting pretty dim now. But I don't want to spend a crazy amount for a few $2 lights

Hey guys trying to change my dash lights out but its nothing like any other post or video I've seen as they all have straight access to a bulb once the cluster is out. Picture for reference

Hey Jordan is your issue similar to this ?

Hey all, Just wondering if any one has done a coil conversion apart from the SAS swap dilmah and Joshy have done. The price is pretty steep but it would be pretty sick to get some coils on the nav instead of the the ole torsion bars. What are your guys thoughts on this...